PL Tone generator -- Wein Bridge Oscillator powered by two 9 volt batteries (not included). - $1
Touch Tone Encoder -- Western Electric Touch Tone Dial mounted in a 4"x4"x2" metal enclosure with power switch. Has a 4 pin DIN connector plus matching cable terminated in a 1/8" mini plug. -- $2
NE556 Oscillator Circuit -- Two pots with anodized gold (colored) knobs, pwr. sw., LED,. & Banana jack outputs -- $3
1 Mhz Oscillator -- built on a small piece of perfboard with an HC-6 crystal on the back. Checked and seems to run on about 15-20 volts. There are a few of these. -- $4 ea.
PPG Electronics project #880-CB -- 13.5V 2 Amp, power supply kit, unbuilt. Most parts are under shrink wrap. Power transformer & main filter cap are missing.-- $2
VHF thing mostly complete -- Double sided circuit board with 3 Motorola MWA120 amplifiers, 5 coils, mounted in Bud 4" x 2-1/4" x 1.5" aluminum box with a BNC connector (unwired). Looks to be finished except for power & I/O -- $15
435 MHz power splitter -- N connectors (3). This is made out of brass sheet stock and is about 15" long by 1" square.-- $10
VHF thing just started -- Pomona 4" x 2.5" x 1.5" cast box with a couple 160-104 capacitors, BNC connectors, a miniature 50K bourns pot., 6 capacitors mounted to gold plated terminals with a very pretty gold flashed internal shield structure. Nothing is soldered -- this was just started. -- $10
Two Meter to 24-28 MHz receiving converter -- At least I think that's what it is... -- 5" x 4" x 1.75" -- $10
Transistor Tester -- per July 76 Ham Radio, p.40. Aluminum case. NPN/PNP select switch is broken but, a replacement is included along with a copy of the article. Nice sealed Weston 50uA meter.-- $12