|
|
I use bluetooth for intercoms so the removal of the DIN connector cable was a no brainer.The charger is attached with two layers of 3M VLB tape . It has a built in SAE connector and because the included cable is a red / black pair, I used heat shrink to cover the wires for the last 6 inches or so up to the connector. It makes the install a little cleaner. The clearance to the pocket door is close. Moving the charger another 1/8" further down the console would be perfect. A small slide switch located on the lower side of the charger allows it to be powered off when not needed. |
|
This harness was made from combining the Show Chrome USB charger for the left pocket. The fuse holder is from the Amazon charger. I added the bullet connectors to allow easy removal for service or modification. A 10 amp fuse is included with the Amazon charger. I changed it to a 5 amp due to the gauge of the Honda wire feeding it. I think if I have a phone or other USB device that pulls more than 5 amps, I have another problem.
If you just want to make your own harness, the two pin connector is a MTW - Hitachi type connector. With the locking tab up, positive is on the right as you face the connector.The bullet connectors are 3.5mm. A double female is available to make things a little cleaner. Cycleterminal.com is one of the vendors I have used. |
|
K2mpw at yaa who? Dot com |
11/21/20 |
|